Acurite 13131 Alarm Clock Bedienungsanleitung Seite 2

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 1
About the Atomic Clock
A clock is considered atomic if it has an accuracy of one second in a million years.
Consumer clocks are considered atomic if they attain this accuracy by receiving a
signal from an atomic clock. In North America, the National Institute of Standards
and Technologies operates an atomic clock in Colorado which transmits the time
codes via the the radio station WWVB. The signal is transmitted in a very low
frequency (60,000 Hz). The Acurite clock you have purchased includes a built-in
receiver which picks up the signal from the WWVB station. For the best possible
reception, place the main unit with the back side facing Colorado. NOTE: Due to solar
radiation in the atmosphere, the atomic clock signal is weaker during the day. Most
synchronization with the WWVB atomic clock signal happens at night when there is
less interference.
Basic Setup
After installing 3 AA Alkaline batteries, the year, month, date, time, time zone and
DST (daylight saving time) preferences must be set initially. After the initial manual
setting, the atomic clock will maintain it’s accuracy and adjust for DST automatically.
The alarm clock will automatically show the current time in Eastern Standard Time.
Select your desired time zone.
Manual Setup
To enter into the setup selection mode, press AND HOLD the “SET CLOCK” button.
1. Set TIME ZONE using “ and ” buttons. Press “SET CLOCK” to confirm.
2. Set DST using ” and “buttons. Press “SET CLOCK” to confirm.
3. Set YEAR using ” and “ ” buttons. Press “SET CLOCK” to confirm.
4. Set MONTH using “and” buttons. Press “SET CLOCK” to confirm.
5. Set DATE using “and” buttons. Press “SET CLOCK” to confirm.
6. Set current time HOUR using ” and “buttons (hold button to fast scroll).
Press “SET CLOCK” to confirm.
7. Set current time MINUTES using “ ” and “ buttons(hold button to fast scroll).
Press “SET CLOCK” to confirm and exit
TO SELECT ºF OR ºC FOR INDOOR TEMPERATURE DISPLAY:
Press the ºF/ºC button located within the battery compartment on the bottom
of the alarm clock.
-2-
-3-
2 • SETUP
3 • OPERATION
Alarm Clock Setting
To set the alarm time, press AND HOLD the “ALARM” button on the side of the alarm
clock until the HOUR flashes to enter into alarm time set mode.
1. Set the alarm HOUR using the “ ” or “ ” buttons (hold button to fast scroll), note
the AM/PM indicator.
2. Press the “ALARM” button to confirm hour selection.
3. Set the alarm MINUTES using the “ ” or “ ” buttons (hold button to fast scroll).
4. Press the “ALARM” button to confirm and exit alarm time set mode.
Alarm Clock ON or OFF
TO TURN ALARM ON: Press AND RELEASE the “ALARM” button. The BELL icon will
appear on the screen and the words “ALARM ON” appear to the left of time display.
TO TURN ALARM OFF: Press AND RELEASE the “ALARM” button. The BELL icon will
disappear on the screen and the words “ALARM OFF” appear to the left of time display.
Alarm Clock SNOOZE function
When the alarm is sounding, you may activate the 8 minute snooze function by firmly pressing
down on the SNOOZE/LIGHT buttom at the top of the alarm clock.
The snooze function may be activated up to 10 times.
Backlight
You may activate the backlight for 5 seconds at any time by firmly pressing down on the
SNOOZE/LIGHT button on the top of the alarm
Relocate or reposition the clock, making sure
the backside of the unit is facing in a direction
toward Colorado from your location.
Heavy stone or metal walls can obstruct the
signal and disrupt reception. Place the clock
at least 3 feet (0.91 m) from other electronic
devices (i.e. TV’s, microwaves, computers,
etc.) that can interfere with wireless signals.
Check to make sure the batteries are installed
correctly. Use only fresh STANDARD “AA”
batteries, not generic or extra strength. Make
certain that the batteries are FRESH. If the
expiration date on your batteries is less than 6
years away, they may not contain a full charge
and can be weak.
Poor Atomic Clock
Reception
(No bars)
PROBLEM
POSSIBLE SOLUTIONS
Display Not Working
4 • TROUBLESHOOTING
Seitenansicht 1
1 2

Kommentare zu diesen Handbüchern

Keine Kommentare